American Water Heater Commercial Ultra Low NOx Gas water Heater Benutzerhandbuch

10

5.  Wait five (5) minutes                   to clear out any gas.  

If you then smell gas,           STOP!  Follow "B" in 

the safety information                above on this label.

 

If you don't smell gas, go to next step.

6.  Turn on all electrical power to the appliance.

7.  Set thermostat to desired setting by first pressing the 

COOLER    and HOTTER    buttons together and 

holding for 1 second. Then press the HOTTER    

button.

8.  If the appliance will not operate, follow the 

instructions "TO TURN OFF GAS TO APPLIANCE" 

and call your technician or gas supplier.

9.  WATER TEMPERATURE ADJUSTMENT

 

 

is approximately 120°F (49°C).

    

If you do not follow these instructions exactly, a fire or explosion 

may result causing property damage, personal injury or loss of life.

•  If  you  cannot  reach  your  gas  supplier,  call  the  fire 

department.

C.  Use only your hand to push in the control buttons. 

Never use tools. If the control buttons will not push 
in,  don’t  try  to  repair  them,  call  a  qualified  service 
technician. Force or attempted repair may result in a 
fire or explosion.

D.  Do not use this appliance if any part has been under 

water. Immediately call a qualified service technician 
to inspect the appliance and to replace any part of the 
control system and any gas control which has been 
under water.

A.  Set thermostat to the lowest setting.

B.  Turn off all the electric power to the appliance 

 

if service is to be performed. 

1.   

STOP!   Read the safety information above  

 

on this label.

2.  Set the thermostat to the lowest setting by first pressing 

the COOLER   and HOTTER   buttons together 

and holding for 1 second. Then press the COOLER 

  button until the WARM indicator light appears.  

3.  Turn the "ON/OFF" swich on the blower control to the 

"OFF" position.

4.  This appliance is equipped with a device which 

automatically lights the burner.

 

DO NOT TRY TO LIGHT THE BURNER BY HAND.

A.  This appliance does not have a pilot.  It is equipped with 

an ignition device which automatically lights the burner.  

Do not try to light the burner by hand.

B. 

BEFORE OPERATING smell all around the appliance 

area for gas. Be sure to smell next to the floor because 
some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS:
•  Do not try to light any appliance.
•  Do not touch any electric switch;
 

do not use any phone in your building.

•  Immediately call your gas supplier from a neighbor’s 

phone. Follow the gas supplier’s instructions.