Graco Inc. 260100 Benutzerhandbuch

The 115 VAC models (260101 and 260102) 
come wired with a short power cord and a 
grounded electrical plug. Power to the unit 
must be 115 VAC single phase. If an extension 
cord is required, it should be a 3-wire cord with 
a ground. Use a 20 amp circuit to supply power 
to the pump.

The 230 VAC model (260104) is not shipped 
with a power cord and plug. You must pur-
chase and install an appropriate power cord 
and plug that meets your local electrical codes.

The 12 VDC model (260100) is not shipped 
with a power cord since the installation will 
determine the length of the power cord.

1. Verify the on/off switch is in the off position.

2. Remove the wiring junction box cover by 

removing the four screws.

3. Use 10 AWG wire to connect the red (+) 

and black (-) wires to the 12 VDC supply.

4. Reattach the wiring junction box cover with 

the four screws.

1. On/Off switch is located on the motor (9). 

Move switch to ON position.

2. Insert nozzle into container or fill tube and 

open nozzle to dispense fluid.

3. Close nozzle to stop flow. The pump has an 

internal bypass valve that will bypass the 
fluid internally with nozzle closed.

4. Immediately after dispensing, turn switch to 

OFF position.

1. Verify pump switch is OFF.

2. Open nozzle to relieve any residual pres-

sure.

3. To prevent damage to the pump, use inlet 

suction screen (260306) when pumping 
used oils.

Do not operate pump dry. Do not run pump for 
more than 5 minutes with nozzle closed.

See Parts, page 8 for items referenced in 
parentheses, i.e., (17).