3M G5 Benutzerhandbuch
Configuration
November 6 2014 – Revision 2.1
Page 14 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
•
Peer-to-Peer – a direct connection between the base station and
the PC using a crossover cable
the PC using a crossover cable
•
Private network – a connection between the base station and a
router, switch or hub using an Ethernet cable. The PC is
somewhere on the same network.
router, switch or hub using an Ethernet cable. The PC is
somewhere on the same network.
•
Enter the configuration mode, see page 11.
•
Select
16 Network Setup
.
•
Change the values for
IP address
,
subnet mask
,
default
gateway
,
E-mail server
, and
Your E-Mail Address Suffix
according to the table below.
•
Cycle the power to the base station.
•
Enter the configuration mode.
•
Select
16 Network Setup
.
•
Change the values for
web server enabled
and
email enabled
to
Yes
.
•
Cycle the power to the base station.
Setting
If Peer-to-Peer
If Private Network
IP Address
Base Station
192.168.99.2
192.168.0.110
(or another unused address in the same address
space as the DHCP address)
PC
192.168.99.1
DHCP
Subnet mask
Base Station
255.255.255.0
255.255.255.0
PC
255.255.255.0
No requirement
Default gateway
Base Station
192.168.99.1
192.168.0.1
(or the switch, router, or hub address)
PC
Leave blank
192.168.0.1
(or the switch, router, or hub address)
E-mail server: 192.28.32.161
Your E-mail address suffix: mmm.com
Logging into the Base Station with a PC
Once the base station is connected and configured you can log into it from any
other computer on the network and operate the station as you would from the
local interface.
other computer on the network and operate the station as you would from the
local interface.
To log into the base station:
•
Using a web browser, type in the IP address of the base station in the
browser’s Address bar, then press
browser’s Address bar, then press
Enter
.
•
Type in your user name and password, then press
Enter
.
•
The default user name is “User1”; the default password is
“1234”.
“1234”.
•
Do NOT type the space between User and the user number (e.g.,
type “User5” instead of “User 5”).
type “User5” instead of “User 5”).
•
If the password has been changed, you can log in using the base
station to find out what it is (
station to find out what it is (
13 Change Passcodes
>
Change User Passcodes
, then look at the current code).