3M G5 Benutzerhandbuch

Seite von 77
Troubleshooting 
  November 6 2014 – Revision 2.1 
Page 58 of 77 
3M™ Drive-Thru Systems Model G5 and Model XT-1 
Operating Instructions 
Problem 
Possible Cause 
Solution 
System is in Always On order taking mode. 
Change the talking mode. 
Audio on all headsets cuts out or is 
interrupted. 
The Backup Intercom is on (the switch is 
engaged). 
Disengage the Backup Intercom switch on 
the base station. 
Loose or frayed wiring. 
Call for authorized service. 
Poor location of Base Station antennae 
(behind large metal  objects, too far from 
work area, etc.). 
Relocate the Base Station, or antennae. 
Inbound audio cuts out (but outbound audio 
is okay) 
The AEC level is too high. 
Reduce the AEC level. 
The headset is too close to loud ambient 
noise. 
Move the headset away from sources of 
loud ambient noise. 
No Talk or listen from the menu sign when 
using the backup wired intercom.  The 
3M™ Wireless Communication System 
Model XT-1 works OK. 
The backup switch on the base station is 
not in the correct position. 
Turn the backup switch ON. 
No power to the backup intercom. 
Turn the backup intercom on or plug in its 
power transformer. 
The volume controls are set too low on the 
backup intercom. 
Turn the volume controls up. 
Defective backup intercom or wiring. 
Call for authorized service. 
No Talk or Page to other headsets from a 
single headset, or Talk or Page buttons 
require excessive pressure to operate. 
Worn or defective Talk or Page switch. 
Call for authorized service. 
Defective headset. 
Low Talk volume on a single headset. 
The holes in front of the microphone are 
plugged with dirt or grease. 
Call for authorized service. 
Operator is not positioning the microphone 
correctly. 
Adjust/reposition the headset 
microphone(s). 
Defective headset. 
Call for authorized service. 
Volume setting on headset is too low. 
Power off and power on headset to reset 
volume level. 
Louder Talk volume or feedback from a 
single headset. 
Volume setting on headset is too high. 
Power off and power on headset to reset 
volume level. 
The holes in back of the microphone are 
plugged with dirt or grease. 
Call for authorized service. 
The “hands free” function does not work. 
The system is operating in half duplex 
mode. 
Hands Free is disabled in half duplex mode. 
Hands free order taking mode not selected. 
Select hands free order taking mode in the 
base station. 
No vehicle alert tone in headset. 
Backup switch not completely pressed (i.e., 
one of the other two buttons is pressed). 
Press the other button into the correct 
location. 
Headset(s) amber LED flashing. 
Headset(s) not registered. 
Register the headset(s).