3M G5 Benutzerhandbuch

Seite von 77
 
Troubleshooting 
 
 3M™ Drive-Thru Systems Model G5 and Model XT-1 
Operating Instructions 
November 6 2014 – Revision 2.1 
Page 59 of 77 
 
 
 
 
 
Battery and Battery Charger Troubleshooting 
XT-1 Battery and Battery Charger
 
Problem 
Possible Cause 
Solution 
No lights come on when a battery is 
inserted into charger. 
Dirty contacts on battery or charger.   
Clean contacts on battery and charger. 
No power to charger. 
Make sure power transformer is plugged 
into charger and a “live” outlet. 
Defective battery. 
Try a known good battery. 
Defective charger. 
Call for authorized service. 
Short battery life. 
Worn out batteries. 
Replace battery. 
Wrong type of power transformer used for 
charger. 
Make sure power transformer is marked 
“Secondary Voltage 14 VAC.” 
The green light on the charger never comes 
on. 
Defective battery. 
Replace the battery. 
 
G5 Battery Indicator Light Modes
 
Indicator 
Mode Description 
Green LEDs 
 
 
 
 
 
The battery is out of the G5 battery Charger and the button has been 
pressed and held down. 
 
Each LED represents 25% charge.  
A fully charged battery would have all 4 LEDS lit Green. 
From the top (in the diagram on the left) if  
    4 successive LEDs lit green indicates a charge between 75% and 100% 
    3 successive LEDs lit green indicates a charge between 50% and 74% 
    2 LED lit green indicates a charge between 25% and 49% 
    1 LED lit green indicates a charge between 0% and 24% 
One of the LED is flashing 
Green 
The battery is in the Charger and is currently charging 
From the top: 
1
st
 LED flashing Green – Battery currently between 0 and 25% charge 
2
nd
 LED flashing Green – Battery currently between 26 and 50% charge 
3
rd
 LED flashing Green – Battery currently between 51 and 75% charge 
4
th
 LED flashing Green – Battery currently between 76 and 100% charge 
Top and Bottom LEDs are 
Green 
Battery End of Life. 
Replace the battery