3M G5 Benutzerhandbuch

Seite von 77
Overview 
  November 6 2014 – Revision 2.1 
Page 8 of 77 
3M™ Drive-Thru Systems Model G5 and Model XT-1 
Operating Instructions 
 
 
CAUTION 
To reduce the risks associated with environmental contamination due to 
battery pack & to lead in the solder: 
 
Dispose of batteries, power supplies, battery charger and base 
station in accordance with federal, state & local requirements.  If 
preferred, return these components to 3M Service Center for recycle. 
 
Other Conventions 
Important Notes and Notes 
Important Note: 
It is strongly recommended that you pay attention to information inside of an 
“Important Note:” box. 
Note: 
You may find information inside of a “Note:” box helpful. 
FCC and Industry Canada Information 
Important Note: 
FCC RF Exposure Statement: 
3M™ Wireless Communication System, Model XT-1 and the 3M™ Drive 
Thru Headset G5 comply with FCC RF radiation exposure limits set forth for 
an uncontrolled environment when operating based on time-averaged output 
power with duty cycle not to exceed 7.63% with a separation distance of 
25mm.  The wireless system must not be co-located or operating in 
conjunction with any other antenna or transmitter.   
 
Use the power supply indoors and in dry locations only. 
 
To reduce the risks associated fire, explosion & property damage: 
 
Do not open, crush, or expose to heat above 55 
°
C/130 
°
F.  For 
additional charging and use instruction refer to operators manual 
 
The battery used in this device may present a risk of fire or chemical 
burn if mistreated. Do not disassemble, heat above 55 C/130 F, or 
incinerate. Replace model XT-1 battery with Lithium-Ion battery 3M 
78- 6911-4721-5 only.  Replace model G5 battery with Lithium-Ion 
battery 3M 78-8117-4656-5 only. Use of another battery may present 
a risk of fire or explosion. Keep away from children. Do not 
disassemble and do not dispose of in fire. 
 
 Always replace batteries, battery chargers and power supplies with 
3M approved units acceptable for use in this system to avoid system 
function & safety concerns. 
 
The 3M™ Drive-thru Headset Battery Charger, G5 12-slot and the 
3M™ Drive-Thru Headset Charging Station, G5 are supplied with two 
power connections to allow for connecting an additional charger 
and/or base station.  During installation, do not connect more than 
one power supply to one charger, or to the interconnected string of 
chargers.   
 
Do not modify this 3M™ Wireless Communication System Model XT-
1, or 3M™ Drive Thru Headset G5.  Install only 3M provided 
components. Use only 3M approved system replacement parts.