Sony PDW-70MD Benutzerhandbuch

36

Playback

  

Ch
apt

er 3  Rec

o

rdi
ng and

 P

la

y

bac

k

This section describes playback of video and audio on the 
unit.

Before starting playback, make the following setting.
Remote/local setting: Set the remote control switch. If 

you set it to REMOTE, also set the setup menu item 
INTERFACE SELECT >REMOTE I/F (“REMOTE” 
and the connector used appear on the display).

Although this unit uses optical discs, it is designed to offer 
the most convenient features of tape playback by VTRs. 

After playback stop
The unit stops at the position where the STOP button was 
pressed.
Press the PLAY button to resume playback at the stop 
position.

After recording
The unit stops at the position where recording ended.
To play back a clip, press the PREV button to move to the 
start frame of any clip, or press the PREV button with the 
PLAY button held down to move to any position.

After disc insertion
The unit stops at the position of the disc when it was most 
recently ejected.
Press the PLAY button to resume playback at the most 
recent position.
The playback position is saved to the disc when the disc is 
ejected, which allows playback to start at that position 
whenever it is loaded into any XDCAM player.

This function is not available when the Write Inhibit tab of 
the disc is set to the recording disabled position, and when 
REC INH on page P1 of the function menu is set to “ON”.

First insert a disc.

To start playback
Press the PLAY button.
Playback starts.
When two or more clips are recorded on the disc, they are 
played back continuously.

To jump to the next or previous clip, then start 
playback
Use the PREV button, NEXT button, jog dial, or shuttle 
dial.

To stop playback
Press the STOP button.
If you play back to the end of the last clip, playback 
automatically stops.
If, in this state, you press the PLAY button, the message 
“ALARM DISC END.” appears on the display.
To carry out playback again, move back to the desired clip 
using the PREV button, jog dial or shuttle dial.

To set shot marks
While playing back a disc, you can set essence marks such 
as SHOT MARK1 and SHOT MARK2 in desired frames.
To set a SHOT MARK1 or SHOT MARK2, hold down the 
M/MARK1 or m/MARK2 button and press the SET 
button.

To erase or change essence marks, use the supplied 
PDZ-1 Proxy Browsing Software.

You can display thumbnail images (index pictures) of all 
clips on the disc, and use them to cue up a desired clip.

PREV button

PLAY button

NEXT button

STOP button

M/MARK1 button and m/MARK2 button

Jog dial

Shuttle dial