Sony PDW-70MD Benutzerhandbuch
64
Recording Continuous Timecode Over FAM Connections
Chapt
er 5 F
ile Ope
rat
ions
i.LINK cable is connected: Disconnect the i.LINK cable
from either this unit or the remote computer, wait for
at least 10 seconds, and then reconnect the
disconnected cable.
at least 10 seconds, and then reconnect the
disconnected cable.
The unit is powered off and an i.LINK cable is
connected: Power the unit on.
To disable FAM connections
Execute one of the procedures described in the previous
section “To make a reconnection” to make a FAM
connection between this unit and the remote computer. To
disable FAM connections, in the setup menu, set
INTERFACE SELECT >i.LINK MODE to “AV/C” (see
page 71).
section “To make a reconnection” to make a FAM
connection between this unit and the remote computer. To
disable FAM connections, in the setup menu, set
INTERFACE SELECT >i.LINK MODE to “AV/C” (see
page 71).
Recording Continuous
Timecode Over FAM
Connections
Timecode Over FAM
Connections
For clips created over a FAM connection, you can record
so that the timecode is continuous with the timecode of the
last frame of the last clip recorded on the disc.
so that the timecode is continuous with the timecode of the
last frame of the last clip recorded on the disc.
To record continuous timecode
Before you start recording, set TCG on page P2 of the
function menu to “INT” and set TC MODE to “REGEN”.
Then write clip files to this unit from a connected computer
or other device.
function menu to “INT” and set TC MODE to “REGEN”.
Then write clip files to this unit from a connected computer
or other device.