Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Viking
  4. KK825
  5. Benutzerhandbuch

Viking KK825 Benutzerhandbuch

Download
Seite von 14
SECTION  TSM 845
PAGE
 1 Of 14
ISSUE
 f
VIKING PUMP, INC.
 
•
 A Unit of IDEX Corporation
 
•
 
Cedar Falls, IA 50613 USA
VIKING PUMP, INC.
 
•
 A Unit of IDEX Corporation
 
•
 
Cedar Falls, IA 50613 USA
TECHNICAL SERVICE MANUAL  
INTRODUCTION
Introduction                                               
1
Safety Information                                                                               
2
Special Information                                       
3
Maintenance                                              
3
Disassembly: Pump                                                                           
4
Disassembly: Coupling                                   
6
Disassembly & Assembly
  of MD-C Series Bearing Housing                     8
Installation of Bushings                                  
10
Assembly: Coupling                                                                         
10
Adjusting Head Gasket End Clearance                                  
11
Pump Rotation                                          
11
Pressure Relief Valve                                                                      
11
Troubleshooting                                                                                  
13
Warranty                                                 
14
UNMOUNTED
UNITS
Units are designated by the 
 
unmounted pump model numbers 
followed by a letter(s) indicating 
drive style 
B = Bracket Mount
R = Viking Reducer Drive
P = Commercial Speed Reducer
(Example: KK-827-MD-C80R)
K-823 , 825 , 827
KK823 , 825 , 827
Model Number Chart
The illustrations used in this manual are for identification 
purposes only and should not be used for ordering parts  
Secure a parts list from the factory or a Viking® representative   
Always give complete name of part, part number or material 
with model number and serial number of pump when ordering 
repair parts  The unmounted pump or pump unit model 
number and serial number can be found on the nameplate 
In the Viking® model number system, the basic size letters 
are combined with the series (823, 825, 827), indicating basic 
pump construction material (steel, cast iron, or stainless steel 
respectively)  
See Model Number Chart.
This manual deals only with Series 823, 825 and 827 magnetic 
drive pumps and couplings  
Refer to Figures 1 thru 23 
for general configuration and nomenclature used in this 
manual  Pump specifications and recommendations are 
listed in Catalog Section 845 
CONTENTS
WARNING !
Persons with surgical implants of a 
metallic or electronic nature should 
avoid working on pump – especially the 
inner magnet assembly.
FIGURE 2
K & KK-825 (cast iron) MD-C80 R 
Unit complete with Motor, “B” 
Gear Reducer, Bearing Carrier 
mounted to base with Mounted 
Pump featuring Tapped Ports.
FIGURE 1
K & KK-827 (stainless steel) MD-C80 B 
Bearing Carrier, Footed Bracket and 
Mounted Pump with Flanged Ports.
TABLE 1
Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com
MAGNETIC DRIVE PUMPS
SERIES 823 – STEEL
825 – CAST IRON
827 – STAINLESS STEEL
SIzES K & KK