Viking SLBL Benutzerhandbuch

SECTION TSM 288

ISSUE

A

PAGE 27 OF  36

•  Install the seal washers (8.08) and the seal screws (8.09)

•  Install  the  L-cup  (8.01)  and  the  rotary  face  (8.02)  into  the 

rotor (2.01)

•  Install the O-ring (8.06), lip-seal (8.17) and the cir-clip (8.18) 

into the seal housing and then install the seal housing (8.16) 

into the casing 

NOTE: On the SLG only the lipseal runs directly on the pump 

shaft and not a sleeve
•  Install the O-ring (8.04) onto the static seal (8.03) and then 

install the static seal into the casing – ensure that the location 

slots line up with the pins in the seal housing

The seals are now assembled.
For rotor and head installation see pump assembly section.

The washers overlap the seal bore – This locates and provides 

drive to the seal.