Panasonic WJ-HD309A Benutzerhandbuch

99

1 s - 30 s (in 1 second intervals)/40 s/50 s/1 min/
2 min/3 min/4 min/5 min
EXT: Alarm output will continue until the ALARM RESET

button is pressed.

The following are available for "Buzzer" (buzzer sound
duration).
When OFF is selected, a buzzer will not sound.
(s: second, min: minute)
1 s - 30 s (in 1 second intervals)/40 s/50 s/1 min/
2 min/3 min/4 min/5 min
EXT: The buzzer will continue until the ALARM RESET

button is pressed.

OFF: The buzzer will not sound.

c Press the SETUP/ESC button.

→ The settings for "Alarm Output" and "Buzzer" will be

applied and the "Event Setup" pop-up menu will be
closed.

8 Power ON Manual REC

Select ON or OFF to determine whether or not to start
recording when the power is turned on by the connected
external timer (or the switch).
ON: Manual recording will start automatically after complet-

ing the system check.

OFF: Manual recording will not start automatically after

completing the system check.

When ON is selected, manual recording will start auto-
matically after completing the system check.

8 VMD Setup

Select ON or OFF to determine whether to enable or dis-
able the motion detection function for each camera chan-
nel.
When ON is selected, perform the settings for the motion
detection area for each camera channel. Up to 4 areas can
be set for a camera channel for the detection area. Refer to
page 114 for further information about the motion detection
function.

[Screenshot 1]
Start operation from the "REC & Event" menu.

z Move the cursor to "VMD Setup" using the arrows button

(C D) and press the SET button.

[Screenshot 2]
The "VMD Setup" pop-up menu will be displayed.

x Select the camera channel to be set by using the

arrows button (C D).

c Rotate the jog dial to select ON for a desired camera

channel for which the motion detection function is to be
applied, and press the SET button.

[Screenshot 3]
The "VMD Area Setup" window will be displayed.

v Move the cross cursor to a desired point to be set as

the start point of the motion detection area using the
arrows button, and press the SET button.

Note: To set all areas on the monitor as the motion

detection area, select "ALL AREAS" and press the
SET button.

[Screenshot 4]
The start point of the motion detection area is assigned.

b Move the cross cursor to a desired point to be set as

the end point of the motion detection area using the
arrows button (C D A B), and press the SET button.

■

■

■

■

■

■

■

■

■

■

■

■

■

■

■

■