Yamaha RX-V3800 Benutzerhandbuch

■

Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals and select either “INT:[SP1]” or 
“INT:[SP2]” for “Zone2 Amplifier” or “Zone3 Amplifier” (see page 97).

Connect the Zone 2 and Zone 3 speakers directly to the SP1 and SP2 speaker terminals and select “Both” for “Zone2 
Amplifier” or “Zone3 Amplifier” (see page 97).

You can select the zone you want to control by using the 
control buttons on the front panel or on the remote control. 

■

Q

ZONE 2 ON/OFF

Q

ZONE 3 

ON/OFF

Q

ZONE CONTROLS

Each time you press Q

, the 

front panel display changes as shown below, and the 
indicator for the currently selected zone flashes for 
approximately 10 seconds. However, no indicator 
flashes when the main zone is selected.

Controls the Zone 2 amplifier or tuner functions.

Controls the Zone 3 amplifier or tuner functions.

y
• You must complete this step within 10 seconds while the 

selected zone flashes in the front panel display. Otherwise, 
the currently selected zone mode is automatically 

canceled. In this case, press Q

 

again.

• The initial setting is ZONE2 when both Zone 2 and Zone 3 

are turned on.

The SP1 or SP2 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or 
more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low 
impedance load resulting in amplifier damage. See this owner’s manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This 
information is found on the back panel of your Receiver.

R

L

R

L
+

R

L