Williams Sound PPA R35-8 Benutzerhandbuch

Seite von 6
2
®
O
PERATING
I
NSTRUCTIONS
1.
Install AA batteries: Open the battery
compartment by lifting the tab on the
back of the receiver with your finger.
To remove depleted batteries, pull up
on the fabric strip.  
IMPORTANT: If Alkaline (non-
rechargeable) batteries are being
installed, slide the battery selection
switch in the battery compartment to
the “Alkaline” position.  See FIG. A
above. If installing NiMH (or recharge-
able) batteries, slide the battery selec-
tion switch to the “NiMH” position. 
Press the batteries into place over the
fabric strip. Be sure to observe proper
polarity (+/–). 
Damage due to improp-
er battery installation may void the war-
ranty on the product.  Close the battery
door. LED will flash when the batteries
are getting low; continue to use until the
sound becomes weak or distorted, or the
unit quits operating, then replace or
recharge batteries.
R
ECYCLING
I
NSTRUCTIONS
Help Williams Sound protect the envi-
ronment!  Please take the time to dis-
pose of your equipment properly.
Product Recycling:
Please do NOT dispose of your Williams
Sound equipment in the household trash.
Please take the equipment to a electron-
ics recycling center; OR, return the prod-
uct to the factory for proper disposal.  
Battery Recycling:
Please do NOT dispose of used batteries
in the household trash.  Please take the
batteries to a retail or community collec-
tion point for recycling.
12/14/07
AA
AA
+
FIG. A