ONKYO TX-SR313 Benutzerhandbuch

■

`

Off:

The format is detected automatically. If no digital 
input signal is present, the corresponding analog 
input is used instead.

`

PCM:

Only 2-channel PCM format input signals will be 
heard. If the input signal is not PCM, the PCM 
indicator will flash and noise may also be produced.

`

DTS:

Only DTS (but not DTS-HD) format input signals 
will be heard. If the input signal is not DTS, the dts 
indicator will flash and there will be no sound.

When “HDMI”, “COAXIAL” or “OPTICAL” is selected 
in the “Audio Selector” setting, you can then specify the 
signal type in “Fixed Mode”.
Normally, the AV receiver detects the signal format 
automatically. However, if you experience either of the 
following issues when playing PCM or DTS material, you 
can manually set the signal format to PCM or DTS.
• If the beginnings of tracks from a PCM source are cut off, 

try setting the format to PCM.

• If noise is produced when fast forwarding or reversing a 

DTS CD, try setting the format to DTS.

• The setting will be reset to “Off” when you change the setting in 

the “Audio Selector” (

).

.

■

`

On 

`

Turn this setting on to display the volume level on the TV 
screen while it is adjusted.

■

`

1, 2, or 3

When several Onkyo components are used in the same 
room, their remote ID codes may overlap. To differentiate 
the AV receiver from the other components, you can 
change its remote ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to change 

the remote controller to the same ID (see below), otherwise, you 
won’t be able to control it with the remote controller.

■

`

10kHz/200kHz:

`

9kHz/50kHz:

Select the frequency step according to your area.

■

`

10kHz:

`

9kHz:

Select the frequency step according to your area.

For AM/FM tuning to work properly, you must specify the 
AM/FM frequency step used in your area. 

• When this setting is changed, all radio presets will be deleted.

■

`

`

When “Auto Standby” is set to “On”, the AV receiver 
will automatically enter standby mode if there is no 
operation for 30 minutes with no audio and no video signal 
input.
“Auto Standby” will appear on the AV receiver’s display 
and OSD 30 seconds before the Auto Standby comes on.
Default setting: On (European, Australian and Asian 
models), Off (North American and Taiwanese models)

• Set  to  “

On”

, the Auto Standby function may activate itself during 

playback with some sources.

Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.