ONKYO TX-SA706 Benutzerhandbuch

73

Some of the settings in this section are set automatically 
by the Automatic Speaker Setup function (see page 49).
Here you can check the settings made by the Automatic 
Speaker Setup function, or set them manually, which is 
useful if you change one of the connected speakers after 
using the Automatic Speaker Setup function.

Note:
The Speaker Setup cannot be carried out while head-
phones are connected to the AV receiver/AV amplifier. 

With these settings, you can specify which speakers are 
connected and a crossover frequency for each speaker.
The following crossover frequencies can be specified: 
“Full Band”, “40Hz”, “50Hz”, “60Hz”, “70Hz”, “80Hz 
(THX)”, “90Hz”, “100Hz”, “120Hz”, “150Hz”, or 
“200Hz”.
Specify “Full Band” for speakers that can output low-
frequency bass sounds adequately, for example, speakers 
with a good sized woofer. For smaller speakers, specify 
a crossover frequency. Sounds below the crossover fre-
quency will be output by the subwoofer instead of the 
speaker. Refer to your speaker’s manuals to determine 
the optimum crossover frequencies.

Please note that THX recommends any THX main 
speakers be set to “80Hz(THX)”. If you set up your 
speakers using the Automatic Speaker Setup function, 
please make sure manually that any THX speakers are 
set to 80 Hz (THX) crossover.

These settings are set automatically by the Automatic 
Speaker Setup function (see page 49).

Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] but-

tons to select “2. Speaker 
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.

q]/[w] but-

tons to select “2. Speaker Con-
figuration”, and then press 
[ENTER].
The “Speaker Configuration” menu 
appears.

q]/[w] but-

e]/

r] buttons to select:

Yes: Select if a subwoofer is con-

nected.

No: Select if no subwoofer is con-

nected.