ONKYO HT-RC460 Benutzerhandbuch

On the “Monitor Out” settings, you can select whether or 
not to have the video sources’ images output through the 
HDMI output.
If you connect your TV to HDMI output, “Monitor Out” 
setting is automatically set and composite video and 
component video sources are upconverted

*

 and output.

• See “Video Connection Formats” (

) for charts 

showing how the “Monitor Out” and “Resolution” settings 
affect the video signal flow through the AV receiver.

■

`

Main:

Select this if your TV is connected to HDMI OUT 
MAIN.

`

Sub:

Select this if your TV is connected to HDMI OUT 
SUB.

`

Both:

Select this if your TVs are connected to HDMI OUT 
MAIN and HDMI OUT SUB. Video signals are 

output from both HDMI outputs at the resolution 
supported by both TVs.

■

`

Through:

Select this to pass video through the AV receiver at 
the same resolution and with no conversion.

`

Auto:

Select this to have the AV receiver automatically 
convert video at resolutions supported by your TV.

`

480p, 720p, 1080i, 1080p:

Select the desired output resolution.

`

1080p/24:

Select this for 1080p output at 24 frames per second.

`

4K Upscaling:

Select this for an output resolution four times that of 
1080p. Depending on the resolution supported by 
your TV, it will result in either 3840 × 2160 or 4096 
× 2160 pixels.

You can specify the output resolution for the HDMI OUT 
MAIN and have the AV receiver upconvert the picture 
resolution as necessary to match the resolution supported 
by your TV.

• You can see the picture by pressing ENTER to check the 

“Resolution” setting (excluding NET input source).

• Depending on the incoming video signal, the video playback may 

not be smooth or the vertical resolution may be lowered. In this 
case select anything other than “1080p/24”.

• With some TVs, there may be no picture when this setting is set 

to “4K Upscaling”. 

• If the “Monitor Out” setting is set to “Sub”, this setting is fixed 

to “Through”.

• If the “Monitor Out” setting is set to “Both”, this setting is fixed 

to “Auto”.

If you connect a video component to an HDMI input, you 
must assign that input to an input selector. For example, if 
you connect your Blu-ray Disc/DVD player to HDMI IN 2, 
you must assign “HDMI2” to the “BD/DVD” input 
selector.
If you’ve connected your TV to the AV receiver with an 
HDMI cable, composite video and component video 
sources can be upconverted

*

 and output by the HDMI 

output. You can set this for each input selector by selecting 
the “- - - - -” option. See “Video Connection Formats” for 
more information on video signal flow and upconversion 
(

Here are the default assignments.

“Setup”

Composite video, 

component video

HDMI

HDMI

Composite video, 

component video

FRONT (Fixed)

Composite video, 

component video

HDMI

HDMI

Composite video, 

component video