ONKYO HT-RC460 Benutzerhandbuch

■

■

To control Zone 2, you must press ZONE2 on the remote 
controller first.

■

■

If your Zone 2 speakers are connected to a receiver or 
integrated amplifier in Zone 2, use its volume control to 
adjust the volume.

■

• To unmute, press ZONE2 followed by MUTING again. Zone can 

also be unmuted by adjusting the volume.

• Only analog input sources are output from the ZONE 2 LINE 

OUT jacks and ZONE 2 L/R terminals. Digital input sources are 
not output. If no sound is heard when an input source is selected, 
verify that the source is connected to an analog input.

• You cannot select different AM or FM radio stations for your 

main room and Zone 2. The same AM/FM radio station will be 
heard in each room. Namely, if you have selected an FM station 
for the main room, that station will also be output in Zone 2.

• When you have selected NET or USB as input selector, the last 

selector selected will be set for Main room and Zone 2.

• When Zone 2 is activated and its input selector is selected, the 

power consumption of standby mode slightly increases.

• While Zone 2 is on, 

u functions will not work.

• When setting the AV receiver to standby mode while Zone 2 is 

active, the Z2 indicator is dimly lit.

• “AUX”, “EXTRA1” and “EXTRA2” cannot be selected as input 

sources for Zone 2.

• When “AUX”, “EXTRA1” or “EXTRA2” is the input source of 

Main room and Zone 2 is set to share the same source, no sound 
will be output from Zone 2.

To turn on Zone 2 and select an input source, press 
ZONE 2 followed by an input selector button within 
8 seconds.
Zone 2 turns on, the Z2 indicator lights on the AV 
receiver’s display.

To select the same source as the main room’s, press 
ZONE 2 twice. “Z2 Sel: Source” appears on the AV 
receiver’s display.

The zone is turned off.

Input selector buttons

8RECEIVER

q/w

8RECEIVER.

Zone 2 turns on, the Z2 indicator lights on the AV 
receiver’s display.

8RECEIVER.
The zone is turned off.

q/w.