Sony STR-DG820 Benutzerhandbuch

F:\SONY SEM\Models_2008\Revision_Data\PMRF3_STR-
DG820\JC080765_3289450431DG820_GB\3289450431\GB07OTH_STR-DG820-CEL.fm

STR-DG820

3-289-450-43(1)

 

 

 

 

 

 

 

 

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

• Contact the radio station and find out 

whether they actually provide the service 
in question. If so, the service may be 
temporarily out of order.

* Models of area code CEL, CEK, ECE only.

• Check the HDMI connection (page 71).
• You cannot listen to the Super Audio CD 

by connecting HDMI.

• Depending on the playback component, 

you may need to set up the component. 
Refer to the operating instructions 
supplied with each component.

• Be sure to use a connecting cable for the 

HDMI jack corresponding to high speed 
(an HDMI version 1.3, category 2 cable) 
when you view images or listen to sound 
during a Deep Color transmission.

• Check the HDMI connection (page 71).
• Depending on the playback component, 

you may need to set up the component. 
Refer to the operating instructions 
supplied with each component.

• Be sure to use a connecting cable for the 

HDMI jack corresponding to high speed 
(an HDMI version 1.3, category 2 cable) 
when you view images or listen to sound 
during a Deep Color transmission.

• Check the HDMI connection (page 71).
• Make sure “CTRL:HDMI” is set to 

“CTRL ON” in the HDMI menu. 

• Make sure the connected component is 

compatible with the Control for HDMI 
function.

• Check the Control for HDMI settings on 

the connected component. Refer to the 
operating instructions of the connected 
component.

• Repeat the procedures of “Preparing 

Control for HDMI function” if you change 
the HDMI connection, connect/disconnect 
the AC power cord, or when there is a 
power failure (page 72).

• Make sure the TV is compatible with the 

System Audio Control function.

• If the TV does not have System Audio 

Control function, set the “AUDIO OUT” 
settings in HDMI menu to
– “TV+AMP” if you want to listen to the 

sound from the TV speaker and 
receiver.

– “AMP” if you want to listen to the 

sound from the receiver.

• If you cannot listen to the sound of a 

component connected to the receiver
– Change the input of the receiver to 

HDMI when you want to watch a 
program on a component connected via 
HDMI connection to the receiver.

– Change the TV channel when you want 

to watch a TV broadcast.

– Select the component or input you want 

to watch when you watch a program on 
the component connected to the TV. 
Refer to the operating instructions of the 
TV on this operation.