Yamaha YSP-4300 Benutzerhandbuch

The screen below is displayed after connecting 
IntelliBeam microphone to the unit.

The screen automatically changes during the AUTO 
SETUP procedure.

If the AUTO SETUP procedure is complete, this unit 
rings the chimes.

AUTO SETUP

(PREPARATION & CHECK)

Please connect the MIC.

Please place the MIC at least

1.8m/6ft away from Sound Pro-

jector. The MIC should be set  

at ear level when seated.

Measurement takes about 3min.

After [ENTER] is pressed, 

please leave the room.

[ENTER]:Start  [RETURN]:Cancel

Follow the instructions below and then leave the room. If you remain 
in the room, you may obstruct the beam, or the microphone may pick 
up any sounds you make, possibly resulting in improper 
configuration of settings. 

ENVIRONMENT CHECK: Success
BEAM MODE: 5Beam/Plus2

SHOW RESULT

MESUREMENT COMPLETE.

[ENTER]:Save set-up.

[RETURN]:Do not save set-up.

Will begin in 10 sec.

Please leave the room

----------

AUTO SETUP START

[RETURN]:Cancel

Measurement results are applied to this unit.

• The measurement results are stored in the internal 

memory of this unit until you run the AUTO SETUP 
procedure again or configure the settings manually.

• You can save the several measurement results pressing 

the SYSTEM MEMORY key (

☞p. 28).

The “AUTO SETUP COMPLETE” screen closes.

Keep the IntelliBeam microphone in a safe place.

AUTO SETUP COMPLETE

Please remove the MIC

from Sound Projector

and the listening position.

Press [SYSTEM MEMORY] key

to save set-up in the memory.

“BEAM+SOUND OPTIMIZE” is selected automatically. When you 
perform “BEAM OPTIMIZE ONLY” or “SOUND OPTIMIZE ONLY” 
only, refer to “AUTO SETUP via setup menu” (

• Wait outside the room during the AUTO SETUP procedure.

Remaining in the room after the AUTO SETUP process begins may 
result in the improper configuration of settings as your body may 
obstruct sound beams or the microphone may pick up sounds you 
make inadvertently. 

• The AUTO SETUP procedure takes about 3 minutes.
• To cancel the AUTO SETUP procedure after it is started, press the 

RETURN key.

If an error occurs, an error buzzer sounds and an error message is 
displayed. For details on error messages, see “If an error message is 
displayed” (

• If “ENVIRONMENT CHECK:Failure” is displayed, accurate 

measurement may not have been possible. See “ERROR-E1” under 
“Error messages” (

☞p. 27) for the remedy to this most common error. 

Press the RETURN key and begin measurement again. 

• Depending on the environment of your listening room, the front left 

and right beam angles and left and right surround beam angles may be 
set to the same value even if “BEAM MODE :5Beam” is displayed as 
a result.

If you do not want to apply the results, press RETURN key.

When AUTO SETUP is performed from the setup menu, the menu 
selection screen of the setup menu appears.

y

y

y

y

y