MTX Audio XT110P Benutzerhandbuch

AMPLIFIER CONTROLS AND POWER WIRE CONNECTION
 

1. Power Terminals

 

   

a. +BATT—connect to the positive terminal of the vehicle’s battery

 

   

b. REM—connect to the Remote Turn On lead from the source unit

 

   

c. GND—connect to a solid metal piece of the vehicle’s chassis (be sure to scrape away any paint  

 

   

  to reveal bare metal where the ground will be attached)

 

2. LED Indicator—green indicates normal operation. Red indicates Thermal Protection mode

 

3. Fuse (20A)

 

4. Remote Control Input 

 

5. Low Level RCA Inputs—use to send audio signal from source unit. Do not use with High Level Signal

 

   Inputs (#9)

 

6. Auto-sensing Turn On Switch—set to OFF to turn the X ThunderLink on or off from the Wired Remote.

 

   Set to AUTO to automatically turn the X ThunderLink on when an input signal is received and

 

   automatically turn it off when the signal is absent for 30 seconds.

 

7. Phase Switch

 

8. Remote Control Switch—set to ON to use the included Wired Remote Control. Set to OFF to make

 

   adjustments from the onboard control panel only.

 

9. High Level Signal Inputs—use to send audio signal from source unit. Do not use with Low Level RCA

 

   Inputs (#5)

Refer to the included wiring harnesses for the Universal Interface Color Code:

White: front left +
White/black: front left –
Gray: front right +
Gray/black: front right –

1

2

3

4

5

9

8

7

6

-"1, Ê1 /

, "/ Ê/1, ‡" 

// ,9

1-

£n»

³ //

,

*"7 ,

­, ®

*,"/ /

­, ®

1-

, "/

‡ *1/

," /

, ,

, "/

" /,"

*-

1/"

/1, Ê" 

" 

"

"

1/"

£näÂ

äÂ

Ê *1/

," /

, ,

FRONT PANEL CONTROLS
 POWER—LED illuminates when the system is turned on.
 BASS 

BOOST—select a boost level between -3dB and +3dB to enhance the bass performance for your

 

  sound system. BASS BOOST is NOT free! Every 3dB of boost costs you twice as much in power.

 

  Make sure to set the fi nal volume after setting the Bass Boost to work best with your system. More is NOT

  

always 

better!

 CROSSOVER—select a Low Pass crossover frequency from 30Hz to 150Hz.
 VOLUME—select a volume for the system that works best with your BASS BOOST setting and your listening
  

preference.

Bad connection of the
power wire, ground wire, or 
remote wire

Check all connections and wiring

Blown fuse

Replace fuse (20A)

Input not connected

Reconnect the inputs 

No signal from source

Verify source is providing signal to 
amp input

Automatic turn-on switch set 
incorrectly

Switch to AUTO and reset source 
signal

Volume is set too high

Lower volume

Bass Boost is too high

Lower Bass Boost 

Head unit output is distorted or 
blown

Replace head unit, try a different 
source

The RCA signal wire is too close 
to the main power wire in the 
vehicle

Rewire signal wire further away or 
shield wire

Inadequate ground  

Check to make sure ground point 
is clean and securely connected 
to bare metal close to the vehicle’s 
frame

Green: rear left +
Green/black: rear left –
Violet: rear right +
Violet/black: rear right –