Wi-Ex YX699 Merkblatt

zBoost

YX699 Signal Meter

Preparing the YX699 Signal Meter for use:

Remove 3 screws from the back of the case to unsecure battery

compartment, remove the cover, install 3 AA batteries, replace

cover and reinstall screws.

To measure signal strength:

1. Attach the supplied rubber whip antenna to the connector at

the top of the meter.

2. Turn on the meter with the power switch on the side of the

signal meter. After a few seconds, the meter will indicate the

received signal strength on the display.

3. Select the desired band by pressing the BAND button on the

front of the meter. The LED will light green for the CEL band

(800 MHz) or orange for the PCS band (1900 MHz). Pressing

the BAND button again will toggle the meter between the CEL

and PCS bands.

4. The meter will now indicate the received signal strength of the

selected band. A greater number indicates a stronger signal.

5. As you move about, the meter will indicate the received signal

strength.

6. Turn off the meter when not in use to maximize battery life.

To measure directional antenna signal strength:

1. Disconnect the supplied whip antenna from the top of the

signal meter.

2. Attach the supplied coax cable and connect the directional

antenna to the signal meter.