JVC CA-WMD90R Benutzerhandbuch
– 7 –
1
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
terminals as illustrated.
2
Turn the AM loop antenna until you have the best
reception.
reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
(The AM loop antenna must remain connected.)
wire to the AM EXT terminal and extend it horizontally.
(The AM loop antenna must remain connected.)
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM antenna
Vinyl-covered wire
(not supplied)
(not supplied)
AM loop antenna (supplied)
Connecting Speakers
You can connect the speakers using the speaker cords.
Right
speaker
Left
speaker
1
Twist the core of the cord at the end of each cord,
then remove the insulation.
then remove the insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
indicated by the speaker terminals on the rear of the unit.
2
3, 4
2
3
1
Black
Red
Speaker cord
Red
1
EN01-09.CA-WMD90R[B]/f
99.3.4, 8:21 PM
7