Motorola DCT700 Benutzerhandbuch
DCT700 Installation Manual
Section 3
Installation
This section provides instructions for installing and cabling the DCT700. To complete the
installation, you must:
!
Connect the cables
!
Supply power to equipment
!
Download configuration information and software
!
Run operational check and diagnostics
This section also includes the procedure for performing a cold initialization of the DCT700.
Before You Begin
Before you begin, review the installation instructions, gather the required items, and complete
the tasks listed below:
!
Verify that you have 75-ohm coaxial cables with F-type connectors and RCA baseband
phono-type cables.
!
Determine if you are connecting the set-top to a standard TV or a composite
(baseband) monitor.
!
Place the set-top on a smooth, flat surface and remove any obstructions that could interfere
with the free flow of air over, under, or around it. Advise the subscriber not to place
anything on top of the unit.
Installing the DCT700
To install the DCT700:
1
Determine if you are connecting the set-top to a conventional TV or to a monitor. To install
the video connection:
!
For a conventional TV, use a 75-ohm coaxial cable with F-type connectors.
!
For a monitor, use an RCA phono cable to connect the
VIDEO
connector to the monitor.
2
Locate the cabling diagram that matches the subscriber’s configuration requirement.
3
Connect the cables as illustrated in the diagram.
4
Perform the basic operational check in this section after the set-top is installed.