Alphasonik PFZ325E Benutzerhandbuch

NOTE:   Alphasonik strongly recommends that you operate your 
system at low volumes prior to the completed installation of your 
Alphasonik speakers.  This will allow a test of the speaker before 
securing it to its permanent location.

CAUTION:   Make sure that all speaker wiring is fully protected from 
cuts, tears and possible wear.  Any short circuit developing as a result 
could severely damage the source unit or possibly the amplifier.  Make 
sure all speaker wires easily reach the speaker terminal with no stress 
on the wires or connectors.

1:   Confirm the mounting location and depth requirements by 

inspecting the area where the speaker will be mounted.  Most 
speakers will fit into stock locations on the vehicle, in this case only 
depth is important.  
 

2:     If the location you have picked does require cutting, you 

may use the supplied template to help you locate and mark the 
mounting location and cuts to be made.  Be careful when cutting out 
the template.  If you cut the template properly, the speaker will be a 
perfect fit.
 

3.      If there is a cosmetic panel where the speaker will be 

mounted, we recommend using a utility knife to carefully cut a hole in 
it.  Confirm the cut by placing the speaker in the hole.  You may 
modify the hole as necessary.
 

4.      If it will be necessary to cut steel, reinstall the cosmetic 

panel in place and use the hole you have previously cut as a template.  
This will help to insure proper cutting and a good fit.  Mark the location 
for the speaker mounting screws, remove the panel and drill the screw 
holes.  When finished you may replace the panel.
 

5.     After cutting and drilling all holes, inspect the mounting 

areas for any metal burrs or rough edges.  File any area that may 
interfere with the mounting of the speaker.
 

6.     Clean any metal shavings from the mounting area and 

check for areas in which water may enter the speaker cavity. Treat the