Sony RDHGTK37IP Handbuch

General

The system has entered standby
mode.

• This is not a malfunction. The system

enters standby mode automatically in
about 30 minutes when there is no
operation or audio signal output
(page 24).

The clock or timer setting is canceled.

• The power cord is disconnected or a

power failure occurred. Set the clock
(page 13) and timer (page 22) again.

There is no sound.

• Adjust the volume.
• Check the connection of the optional

equipment, if any (page 11).

• Turn on the connected equipment.

There is severe hum or noise.

• Move the system away from sources of

noise.

• Connect the system to a different wall

outlet.

• Install a noise filter (commercially

available) to the power cord.

• Turn off surrounding electrical

equipment.

The timer does not function.

• Check the timer setting and set the

correct time (page 22).

• Cancel the Sleep Timer function

(page 22).

The remote control does not function.

• Remove the obstacles between the

remote control and the unit.

• Move the remote control closer to the

unit.

• Point the remote control at the unit’s

sensor.

• Replace the batteries (R6/size AA).
• Move the unit away from the

fluorescent light.

“CHILD” and “LOCK” appear when
you press any button on the unit.

• Set the Child Lock function to off

(page 24).

iPod/iPhone

There is no sound.

• Make sure the iPod/iPhone is connected

securely.

• Make sure the iPod/iPhone is playing

music.

• Make sure the iPod/iPhone is updated

with the latest software.

• Adjust the volume.

The sound is distorted.

• Make sure the iPod/iPhone is connected

securely.

• Turn down the volume.
• Set the “EQ” setting of the iPod/iPhone

to “Off” or “Flat”.

Unexpected track changes occur
during playback.

• Turn off the “Shake to Shuffle” function

(changing tracks by shaking the iPod/
iPhone) on the iPod/iPhone when
listening to music on the iPod/iPhone at
high volumes. If this function is
enabled, unexpected track changes may
occur due to the vibrations caused by
sound pressure from the system.

The iPod/iPhone does not function.

• If the battery of the iPod/iPhone is

empty, it may not work with this system.
In this case, recharge it with a computer,
etc. then connect it to the system.

• Quit all running applications on your

iPod or iPhone before using it with the
system. For details, refer to the
operating instructions of your iPod/
iPhone.

• Make sure the iPod/iPhone is connected

securely.

• Make sure the iPod/iPhone is updated

with the latest software.