Alphasonik PFZ410E Benutzerhandbuch

     Once you have tested your system and have confirmed that it 
is operating properly, turn off your system and prepare for the 
final mounting of the speakers.

   
 

1.   Position the speaker into the mounting hole and 

reconfirm the correct mounting location and hole placement.  
Screw clips are provided to insure a snug fit.  Place screw clips 
over the metal surface and line up the hole with the hole you 
have previously drilled.  Place the speaker into the hole, align the 
mounting holes and proceed to insert the screws.  Be sure to 
tighten the screws evenly as to not warp the speaker frame.

 

2.   Turn your system back on and confirm the speaker's 

operation, first at low volume and then you may increase the 
volume as you desire.
 

    

3.  The next steps will aid in the proper mounting of the 

speaker grilles.  Follow these steps carefully and be patient.  
First, locate the special bonding rubber which is located between 
the waxed paper in the hardware package.
 

 

4.  Carefully  inspect  the mounting  ring  where the grill  

will be inserted.  You will notice 4 to 6 channeled areas.  This is 
the area where the bonding rubber will secure the grill to the 
speaker.
 

    

 

5.   Break off pieces of the bonding rubber that correspond 

to the size of the channels and insert it snugly in place.  Once all 
of the channels have been filled, carefully insert the grille and 
press it firmly into place.