Uniden r035 Benutzerhandbuch

5

1.  If your phone came with any  

accessory handsets and chargers, 

connect a charger AC adapter to 

each charger's 

 jack and 

set the plug into the notch as 

shown. (These adapters might 

already be connected.) 

Plug the other end of the adapter 

2. 

into a standard 240V AC power 

outlet.

To attach the stand, you have to decide if you want the repeater to 

3. 

rest on a desk or hang on a wall. 

For desktop use, turn the stand so the locking tabs that say 

are facing the base with the arrows pointing up. 

OR 

For wall mount use, turn the stand so the locking tabs that say 

 are facing the base with the arrows pointing down.

Align the stand with the notches on the repeater.

4. 

Slide the stand onto the notches until it clicks into place. (To 

5. 

remove the stand, pull the locking tabs up and back. Then, slide 

the stand straight off the same direction you put it on.)

For wall mount use, place the mounting slots (hole spacing is 

6. 

30mm horizontal) over the pins on the wall, and slide the base 

down to lock it into place.

Make sure you have a strong signal from the base (at least 3 bars 

 x

in the handset display).

Put the charger at least 10m away from the base or any other 

 x

Repeater/Charger. (If you put the charger on a different floor from 

the base, don't forget to allow 10m vertically, also.)

XDECT R035 OM.indd   5

22/9/11   1:50:59 PM