Multiquip MC3SBA (B&S) Benutzerhandbuch

1. Place the

 choke  lever (Figure 21) in the CHOKE   (CLOSED)

position if starting a 

cold engine.

DO NOT attempt to operate the mixer until
the Safety, General Information and
Inspection sections of this manual have
been read and  thoroughly understood.

3. Place the 

throttle lever (Figure 22) in the "TURTLE"  (IDLE)

position.

4. Grasp the starter grip (Figure 23) and slowly pull it out. The

resistance becomes the hardest at a certain position, corre-
sponding to the compression point. PULL the starter grip
briskly and smoothly for starting.

This section is intended to assist the operator with the initial
start-up of the walk-behind trowel.  It is extremely important that
this section be read carefully before attempting to use the trowel
in the field.

2. Place the

 choke lever (Figure 20) in the RUN (OPEN)

position if starting a 

warm  engine engine or if the

temperature is warm.

7. If the engine has started, slowly return the choke lever   to the

RUN (OPEN) position if needed (Figure 24 ). If the engine
has not started repeat steps 1 through 4.

8. Before the mixer is placed into operation, run the engine for

several minutes.  Check for fuel leaks, and noises that
would associate with a lose V-belt cover or component.

9.

To begin mixing, place the throttle lever (Figure 25) in the
"

RABBIT"  (FAST) position