Eclipse - Fujitsu Ten CD5444 Benutzerhandbuch
26
ESN security operating procedure
[FUNC] button
Buttons [1] to [4]
How to operate the ESN (Memory Stick) security
Check that the Power is OFF.
Press and hold button [1], then the [FUNC] button, and
hold both for more than one second.
hold both for more than one second.
A [SEC] message appears, in two seconds it will change to
[MS].
[MS].
2
1
How to record a security code
ATTENTION
•If a Memory Stick has already been inserted, a [MS EJECT]
message appears. In this case, eject the Memory Stick and
insert again. (Refer to "Ejecting the Memory Stick" on page 72
for details on ejection of the Memory Stick.)
insert again. (Refer to "Ejecting the Memory Stick" on page 72
for details on ejection of the Memory Stick.)
•If a security is activated, recording the security code is not
available.
Insert the Memory Stick into the slot.
A [- - - -] (security code input display) appears.
(Refer to "Listening to MG Memory Stick" on page 40 for
details on insertion of the Memory Stick.)
(Refer to "Listening to MG Memory Stick" on page 40 for
details on insertion of the Memory Stick.)
Input a security code by pressing buttons [1] to [4].
Enter a four-digit security code using digits 0 to 9, A to F.
The number (shown on the display) changes in ascending
order between 0 and 9, A and F each time the button is
pressed. Each button number (1 to 4) corresponds to each
digit (first to forth) of the security code.
The number (shown on the display) changes in ascending
order between 0 and 9, A and F each time the button is
pressed. Each button number (1 to 4) corresponds to each
digit (first to forth) of the security code.
4
3