Jensen Tools MCD4030 Benutzerhandbuch
MCD4030
3
Preparation
Tools and Supplies
The following tools and supplies are needed to install the unit.
•
Torx type, Flat and Phillips screwdrivers
•
Wire cutters and strippers
•
Tools to remove existing radio (screwdriver, socket wrench set or other tools)
•
Electrical tape
•
Crimping tool
•
Volt meter/test light
•
Crimp connections
•
18 gauge wire for power connections
•
16-18 gauge speaker wire
Speaker Requirements: Only connect speakers rated in the load impedance of 4 ohms. Speakers
with a load impedance less than 4 ohms could damage the unit.
with a load impedance less than 4 ohms could damage the unit.
Choosing a Mounting Location
The following tips will help you determine the best location for mounting the unit:
•
•
Select a location that does not interfere with the normal functions of the driver and will not
cause injury to the driver or a passenger in the event of a sudden stop or other emergency.
cause injury to the driver or a passenger in the event of a sudden stop or other emergency.
•
Do not install the unit in a location that would subject it to high temperatures (such as in
direct sunlight or next to a heating unit), dust, dirt or excessive vibration.
direct sunlight or next to a heating unit), dust, dirt or excessive vibration.
•
Install the unit in a horizontal position if at all possible. If the installation angle exceeds 30
degrees from the horizontal, the unit may not function optimally.
degrees from the horizontal, the unit may not function optimally.
•
If the installation requires the drilling of holes or other vehicle modifications, consult the
nearest dealer for assistance.
nearest dealer for assistance.
•
Before completing installation of the unit, connect the wiring temporarily to ensure that the
unit operates properly in the selected mounting location.
unit operates properly in the selected mounting location.
Preparación
Herramientas y Provisiones
Las siguientes herramientas y provisiones son necesarias para instalar el radio:
•
Llave torx, destornilladores plano y Phillips
•
Cúter y peladores de cables
•
Herramientas para remover la radio existente (destornillador, equipo de llave de casquillo y
otras herramientas)
otras herramientas)
•
Cinta aisladora
•
Enganchador
•
Voltímetro / luz de prueba
•
Conexiones para enganchar,
•
Cable de calibre 18 para conexiones eléctricas, cable de altoparlante de calibre 16w[TJeeVgTDbre 1697.8( to hs[TJeeV 97.ueri)-7.5oslonexi4(voz: Solame7.5(dentep)14.erl5(existe2105nexi)]TJ16.3383 0 TD0d)-stric-6.7-7.4(s)4vo[(l)4.5( other-7(l)4.ime)-7.4(ud5.3i(l)4 in the4-7.6(t)-0.2105nha)-8(dor)]TJ0 -1.2556 TD0.0005 ohTw[(•ms. Alt, cable de34vo[Tw[(•sp)14iona.5( s p)15g(l)4.imeeda.3i(lm[Tw[(•nir)ad)-st4 ohm(C)ued5. daTw[(•ñaa)-0.on dad-7.4(6)-14.8(ación)]TJ/TT4 1 T4.92539.1.98 37.62-1.2556 TD375 TD0E4(e)n)-04.8(l)4ltLu-19nIns9n09noltil