Sharp XL-DH350NH Benutzerhandbuch

04/1/28

XL-DH350NH EN.fm

Simply remove the iPod from the iPod dock. It is safe to do 
so even during playback.

Note:
When navigating the iPod menus with remote control, do 
not operate any of the buttons on the iPod unit. The volume 
level is adjusted by pressing the VOL (+ or –) button on the 
main unit or the remote control. Adjusting the volume on 
the iPod unit gives no effect.

iPod operation:
The operations described below depend on the generation 
iPod you are using.

System on operation:
When the main unit is powered on, the iPod unit will 
automatically power on when docked in the unit (including 
TIMER function/exclude USB function).

System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked 
iPod unit will automatically turn to stand-by mode.

■ To insert iPod adaptor

Open the iPod cover by pulling up the tip.

Insert the iPod adaptor into the iPod dock and connect
your iPod.

■ To remove iPod adaptor

Insert the tip of a screwdriver (“–” type, small) into the iPod 
adaptor hole as shown and lift upward to remove.

pull up

iPod

Dock connector

iPod (bottom)

iPod dock

iPod

connector

iPod adaptor

■ iPod playback

Press the ON/STAND-BY button to turn the power on.

Press the iPod button on the remote control or
FUNCTION button repeatedly on the main unit to
select iPod function.

Insert iPod unit in iPod dock of main unit.

Press the  /  button to start playback.

■ To disconnect iPod

■ Navigating the iPod menus

Press the MENU button to view the menu on iPod unit.
Press it again to go back to previous menu.

Use the TUNING (

 or 

) button to select an item on

the menu and then press ENTER button.