Alpine 68-16909Z79-A Benutzerhandbuch
27
-EN
01GB05CDE121.fm
ALPINE CDE-121 68-16909Z79-A (EN)
Installation
• The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along
the guides on either side. The unit can now
be removed from the mounting sleeve.
be removed from the mounting sleeve.
3. Pull the unit out, keeping it unlocked as you
do so.
<JAPANESE CAR>
Secure the ground lead of the unit to a clean metal spot
using a screw (*
3
) already attached to the vehicle’s chassis.
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
detachable front panel.
If the detachable front panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
1
* If the installed mounting sleeve is loose in the
dashboard, the pressure plates may be bent slightly to
remedy the problem.
remedy the problem.
Remove the mounting sleeve from the main
unit (see “Removal” on page 27).
unit (see “Removal” on page 27).
2
Detachable Front Panel
Less than 35°
Mounting Sleeve
(Included)
(Included)
Dashboard
This unit
Pressure
Plates
Plates
*
Metal Mounting
Strap
Strap
Chassis
Hex Nut (M5)
Bolt Stud
Ground Lead
Screw
This unit
*
2
*
1
Reinforce the head unit with the metal
mounting strap (not supplied). Secure the
ground lead of the unit to a clean metal spot
using a screw (*
mounting strap (not supplied). Secure the
ground lead of the unit to a clean metal spot
using a screw (*
1
) already attached to the
vehicle’s chassis.
• For the screw marked “*
2
”, use an appropriate screw
for the chosen mounting location.
Connect each input lead coming from an
amplifier to the corresponding output lead
coming from the left rear of the CDE-121.
Connect all other leads of the CDE-121
according to details described in the
CONNECTlONS section.
amplifier to the corresponding output lead
coming from the left rear of the CDE-121.
Connect all other leads of the CDE-121
according to details described in the
CONNECTlONS section.
3
Slide the CDE-121 into the dashboard until it
clicks. This ensures that the unit is properly
locked and will not accidentally come out
from the dashboard. Install the detachable
front panel.
clicks. This ensures that the unit is properly
locked and will not accidentally come out
from the dashboard. Install the detachable
front panel.
Bracket Keys
(Included)
(Included)
This unit
Front Frame
This unit
Screws (M5 × 8)
(Included)
(Included)
Mounting Bracket
Ground Lead
*
3
01GB00CDE121.book Page 27 Monday, December 13, 2010 2:03 PM