Alpine 68-16909Z79-A Benutzerhandbuch

Seite von 93
4
-EN
01GB03CDE121.fm
ALPINE CDE-121 68-16909Z79-A (EN)
Never Attempt the Following
Do not grip or pull out the disc while it is being pulled back into 
the player by the automatic reloading mechanism.
Do not attempt to insert a disc into the unit when the unit power 
is off.
Inserting Discs
Your player accepts only one disc at a time for playback. Do not 
attempt to load more than one disc.
Make sure the label side is facing up when you insert the disc. 
“ERROR” will be displayed on your player if you insert a disc 
incorrectly. 
Playing a disc while driving on a very bumpy road may result in 
skips, but this will not scratch the disc or damage the player.
New Discs
To prevent the CD from jamming, “ERROR” is displayed if 
discs with irregular surfaces are inserted or if discs are inserted 
incorrectly. When a new disc is ejected immediately after initial 
loading, use your finger to feel around the inside of the center 
hole and outside edge of the disc. If you feel any small bumps or 
irregularities, this could inhibit proper loading of the disc. To 
remove the bumps, rub the inside edge of the hole and outside 
edge of the disc with a ballpoint pen or other such instrument, 
then insert the disc again.
Irregular Shaped Discs
Be sure to use round shape discs only for this unit and never use 
any special shape discs.
Use of special shape discs may cause damage to the mechanism.
Installation Location
Make sure this unit will not be installed in a location subjected 
to:
Direct sun and heat
High humidity and water
Excessive dust
Excessive vibrations
Correct Handling 
Do not drop the disc while handling. Hold the disc so you will 
not leave fingerprints on the surface. Do not affix tape, paper, or 
gummed labels to the disc. Do not write on the disc.
Disc Cleaning 
Fingerprints, dust, or soil on the surface of the disc could cause 
the CD player to skip. For routine cleaning, wipe the playing 
surface with a clean, soft cloth from the center of the disc to the 
outer edge. If the surface is heavily soiled, dampen a clean, soft 
cloth in a solution of mild neutral detergent before cleaning the 
disc.
Disc Accessories 
There are various accessories available on the market for 
protecting the disc surface and improving sound quality. 
However, most of them will influence the thickness and/or 
diameter of the disc. Using such accessories can cause the disc 
to be out of standard specifications and may create operational 
problems. We recommend not using these accessories on discs 
played in Alpine CD players.
Center Hole
Bumps
Center Hole
New Disc
Outside 
(Bumps)
CORRECT
INCORRECT
CORRECT
Transparent Sheet
Disc Stabilizer
01GB00CDE121.book  Page 4  Monday, December 13, 2010  2:03 PM