Alphasonik PBAT10E Benutzerhandbuch

 

Before starting your installation we recommend to disconnect 

the battery so there can be no damage done to the electrical system 

of the vehicle.  Before disconnecting the battery make sure that the 

vehicles source unit does not have a password and if so you have the 

password in hand to disable the security feature of the source unit.

Make sure your source unit (Cassette, CD, DAT, DVD, etc) is turned off 

while connecting the  terminals.  Turn on the various components and 

slowly advance the volume.  Remember to check and recheck all con-

nections to insure proper use.

1. 

Alphasonik recommends using the wires that were supplied with 

 

the the kit. Thinner gauge wire may easily be severed and can 

 

cause damage to your system should any bare wire come in 

 

contact with the vehicle’s chassis.

2. 

Make sure that your audio system is off while installing and con

 

necting your new Alphasonik enclosure.  Failure to do so could 

 

result in damaging the speaker beyond repair.

3. 

Be sure to route the wires to the amplifier where it will be free 

 

from sharp objects.

4. 

To insure long-term reliability, all bare wires and wire-to-wire 

 

connections should be soldered and insulated with heat shrink 

 

or electrician’s tape.  Under no circumstances should you leave 

 

any bare wires uncovered, as this can and will lead to the dam

 

age of your speakers.

5.        Once you have tested your system and have confirmed that it is 

 

operating properly, turn off your system and prepare for the final 

 mounting.