NorthStar Navigation 961XD Benutzerhandbuch

Seite von 86
SECTION TWO - Installation
961 INSTALLATION MANUAL Revision A
Page 15
To avoid mutual interferences among different antennas on the vessel, 
refer to the drawing of recommended separation distances in Figure 5: 
‘Separation distances between antennas,’ below.
Figure 5 shows the minimum recommended distances for the separation 
of the GPS antenna from other antennas and physical mounting surfaces. 
Under normal circumstances, following these guidelines usually result in 
a relatively trouble-free installation.
The installer may want to adjust these distances, however, depending on 
the particular equipment and how it is configured. Since each installation 
is unique
—according to the wishes of the customer—this information 
should be used only as a guideline. It is not absolution in determining 
the best locations for every possible equipment configuration.
 Figure 5:  Separation distances between antennas 
Choosing the AN205-P combination antenna location
A combination GPS/DGPS antenna is available for applications involving 
serious grounding problems (which creates noise issues with the beacon 
receiver), where optimum portability is required, or when only a single 
NOTE:
Be especially careful about the distance between the combo
antenna and any sources of magnetic interference (for exam-
ple, the INMARSAT antenna).