JL Audio SB-T-SEQ/10W3v2-D2 Benutzerhandbuch
➔
➔
➔
➔
➔
➔
STEP 7: Insert supplied Socket Set Cup
Screw into the enclosure so the rod extends
approximately 1/4” out of the enclosure.
Screw into the enclosure so the rod extends
approximately 1/4” out of the enclosure.
STEP 11: Adjust the Socket Cup Set Screw,
so that is extends 1 1/2” out of the enclosure.
so that is extends 1 1/2” out of the enclosure.
Cont.
From
Page 1
Continued on Page 3
➔
➔
STEP 8: Roll the floor carpet back to expose
the metal floor in the location shown above.
Place the supplied wax square on the metal
floor as shown above.
the metal floor in the location shown above.
Place the supplied wax square on the metal
floor as shown above.
STEP 12: Insert the supplied U-bolt in
factory hole.
factory hole.
(located at the top of the enclosure location
as shown above)
as shown above)
➔
STEP 13: Run speaker wires to the location
of the Stealthbox. Check the Stealthbox for
proper operation.
of the Stealthbox. Check the Stealthbox for
proper operation.
STEP14: Using the supplied 1/4”washer, 1/4”
lock washer and 1/4”x1”bolt. Mount the L-
bracker to top of the enclosure.The bottom
of the L-brackt needs to point towards the
driver’s side fender.
lock washer and 1/4”x1”bolt. Mount the L-
bracker to top of the enclosure.The bottom
of the L-brackt needs to point towards the
driver’s side fender.
STEP 15: Place the Stealthbox in its proper
location, making sure to place the threaded
rod into the previously drilled hole in the
floor.
location, making sure to place the threaded
rod into the previously drilled hole in the
floor.
STEP16: Place the supplied 1/4’lock washer,
1/4” flat washer in that order onto the
1/4”x1” bolt. Pass the bolt through the
mounted L-bracker and thread into the U-
bolt installed in STEP 12. Do not fully tighten.
1/4” flat washer in that order onto the
1/4”x1” bolt. Pass the bolt through the
mounted L-bracker and thread into the U-
bolt installed in STEP 12. Do not fully tighten.
STEP 9: Place the Stealthbox into place so as
to allow the Socket Set Cup Screw to make
an impression in the wax square.
to allow the Socket Set Cup Screw to make
an impression in the wax square.
STEP 10: Using a 1/2” drill bit, drill a hole
through the metal floor in the location of the
impression in the wax square.
through the metal floor in the location of the
impression in the wax square.
S B - T- S E Q / 1 0 W 3 v 2 - D 2 , J L AU D I O, I n c 2 0 0 2
S h e e t S K U # 0 1 1 1 1 1 R ev i s i o n 1 0 / 3 0 / 0 2
Pa g e 2
w w w . j l a u d i o . c o m
➔