ONKYO CS-265DAB Benutzerhandbuch

Seite von 270
En-
6
Package Contents
Make sure you have the following items:
* In catalogs and on packaging, the letter at the end of 
the product name indicates the color. Specifications 
and operation are the same regardless of color.
You can improve the sound quality by attaching the 
included floor pads to raise the speakers off the surface 
and reduce the contact area. The floor pads also make 
the speakers stable and prevent them from slipping.
Remove the insulation sheet before using the remote 
controller.
When using the remote controller, point it toward the 
CD receiver’s remote control sensor, as shown below.
Installation Location
This unit and its remote controller might become 
discolored by ultraviolet or other light components if 
you use them in direct sunlight, or under fluorescent 
lighting or germicidal lamp.
Use only a battery of the same type (CR2025).
Note:
• If the remote controller doesn’t work reliably, try 
replacing the batteries.
• If you intend not to use the remote controller for a 
long time, remove the batteries to prevent damage 
from leakage or corrosion.
• Expired batteries should be removed as soon as 
possible to prevent damage from leakage or 
corrosion.
• If the remote controller does not operate when it is 
used for the first time, try performing the following 
operations.
1. Hold down the remote controller’s VOLUME [–] 
button (for at least ten seconds). If the remote 
controller still does not operate, repeat this 
operation.
2. Remove the button battery, wipe it with a dry 
cloth, and then insert it again.
Caution:
• Replacing the battery incorrectly may cause an 
explosion. Use only a battery of the same type or an 
equivalent.
CD Receiver (CR-265DAB)
Remote controller (RC-892S)
indoor DAB/FM antenna
Power cord
(Plug type varies from country to country.)
Speakers (D-T25)
Speaker cables
8 floor pads
Using the Included Floor Pads for 
speakers
Using the Remote Controller
Floor pads
Bottom
Ap
pr
ox
. 5
 m
 (1
ft.
)
Remote control sensor
CR-265DAB
Replacing the Battery
Battery holder
Place the battery in 
the battery holder with 
the positive (+) side 
facing up, and then 
insert the battery 
holder into the remote 
controller.
While pressing a tab on the back of the 
remote controller in the direction of the 
arrow, pull out the battery holder.
Back side