Motorola DSR-6400 Benutzerhandbuch
3
36
Port Menu
Use this menu to configure RF In ports (Port 1 through Port 8). This menu is not available when the
Manual Tune menu has the Input field set to ASI In or GigE In. That option is described on page 32.
Manual Tune menu has the Input field set to ASI In or GigE In. That option is described on page 32.
Because the unit has eight RF input ports that can potentially be used to switch and tune signals
from multiple satellite antenna, the unit demands there be an accurate association of the port with
the Satellite and Polarity designators programmed in the Uplink encoder system(s) to which we
plan to downlink from on each port.
from multiple satellite antenna, the unit demands there be an accurate association of the port with
the Satellite and Polarity designators programmed in the Uplink encoder system(s) to which we
plan to downlink from on each port.
Because accuracy is critical, a default Auto mode automatically updates the Sat (Satellite) and Polar
(Polarity) fields for the one port that is currently being tuned. This automatic population of the fields
occurs upon entry of acceptable channel information.
(Polarity) fields for the one port that is currently being tuned. This automatic population of the fields
occurs upon entry of acceptable channel information.
To ensure success in getting initial authorization, decryption, and output, leave this menu
unchanged in Auto mode (as shown below).
unchanged in Auto mode (as shown below).
If the Uplink Signal Provider gives detailed instructions, set the Mode field to Manual and set the
Sat (Satellite) field and Polar (Polarity) field. Any mismatch between what is entered into these
fields and the Uplink encoder Satellite and Polarity designations for the services will prevent
authorization decryption and service output. Satellite names and polarity designators for a given
service do not necessarily reflect actual satellite names or even the correct polarity of the actual
signal. These values are set within the provider’s encoder system.
Sat (Satellite) field and Polar (Polarity) field. Any mismatch between what is entered into these
fields and the Uplink encoder Satellite and Polarity designations for the services will prevent
authorization decryption and service output. Satellite names and polarity designators for a given
service do not necessarily reflect actual satellite names or even the correct polarity of the actual
signal. These values are set within the provider’s encoder system.
ID Field
Default: 1
Use this field to choose which port to configure (1 through 8). Press the 4 button until the cursor
is at the ID field, press ENTER to move into the field. Use the buttons to choose a port and
press ENTER to confirm the selection and exit the field.
Mode Field
Default: Auto
Use the Mode field to select the mode for port setup. Press the 4 button until the cursor is at the Mode
label, and press ENTER to move into the field. Press the buttons to choose the desired mode
(either AUTO and MANUAL) and press ENTER to confirm the selection and exit the field.
E 1 Auto ---
---
PORT ID Mode Sat Polar