Samsung SCO-2080RP Benutzerhandbuch

COLOR CCD CAMERA

User Guide

COLOR CCD CAMERA

User Guide

• When making a control system to control the camera, please use to the protocol

SAMSUNG-T, SAMSUNG-E, PELCO-P, PELCO-D, VICON, PANASONIC, BOSCH, HONEYELL).

• When you connecting to RS-485 CONTROL TERMINAL, please peel off the outer

skin inside the RS-485 CONTROL TERMINAL.

• In case of SCC-101 connection, change communication mode to

『

8-E-1

』

at 

『

Communication

configuration

』

menu. (For more information, refer to SCC-101 manual.)

Notes

•  Coaxial Communications System

•  OSD Control method

DVR

300m

3C2V(RG-59/U)

450m

5C2V(RG-6/U)

600m

7C2V(RG-11/U)

– Video Cable
   The camera's video output port is connected to the monitor with a BNC coaxial cable, 

shown below : If the distance between the camera and the monitor exceeds the 
recommended maximum, please use an auxiliary video amp.

• If the camera is controlled through coaxial communication, please use a video

amp intended for coaxial communications. Regular video amps do not transfer
coaxial signals.

Notes

Using RS-485 communication will enable you to control the OSD menu from a SAMSUNG 
TECHWIN System Controller or DVR.
(1) Connection to a PC.
 

 Connect the camera to the PC via a RS-485 converter using RS-485 and a serial cable.

  EX)  SERIAL PORT OF THE PC(COM1) → SERIAL CABLE → RS-485 CONVERTER → RS-485 

CONTROL CABLE 

 WHITE (TRX+)

RS-485+

 BLUE (TRX-)

RS-485-

* RS-485 Communication establishment initial value

(+) CONNECTION TERMINAL

WHITE (TRX+)

(-) CONNECTION TERMINAL

BLUE (TRX-)

Camera ID

BAUD RATE

UART MODE

RET PKT

1

9600

8-NONE-1

ENABLE

(2) Connection to a DVR or System Controller.
    Connect the RS-485 cable to the connection ports of the DVR or System Controller.

WHITE (TRX+)

BLUE (TRX

-)

SET

MENU/ENTER

OSD KEY

UP

UP KEY

JOYSTICK UP

DOWN

DOWN KEY

JOYSTICK DOWN

LEFT

LEFT KEY

JOYSTICK LEFT

RIGHT

RIGHT KEY

JOYSTICK RIGHT

•

: BNC

• ---- : RS-485