IBM 41Y Benutzerhandbuch
24
Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,
Network driver interface specification 2.01
(OS/2) driver messages
(OS/2) driver messages
This section provides explanations of the error messages for
the NDIS 2.01 (OS/2) drivers, and suggested actions to
resolve each problem.
the NDIS 2.01 (OS/2) drivers, and suggested actions to
resolve each problem.
PCNTNW-
NW-127
NW-127
The local bit in the node address
override was set.
override was set.
Explanation: The local bit in the IEEE
address format indicates that the
addresses are being managed locally. If
you use the node address override
capabilities of this driver to enter a new
address, the local bit must be set. You
entered an address without the local bit
set. The driver has set the local bit.
Action: None necessary, message is for
information only.
address format indicates that the
addresses are being managed locally. If
you use the node address override
capabilities of this driver to enter a new
address, the local bit must be set. You
entered an address without the local bit
set. The driver has set the local bit.
Action: None necessary, message is for
information only.
PCNTNW-
NW-164
NW-164
The device was not found.
Explanation: The driver cannot find an
Ethernet controller in the server.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic
programs” on page 11 to run the
diagnostic programs.
Ethernet controller in the server.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic
programs” on page 11 to run the
diagnostic programs.
PCNTNW-
NW-165
NW-165
The device was not found at
IOADDRESS.
IOADDRESS.
Explanation: The Ethernet controller
cannot be found at the I/O address
specified.
Action: The Ethernet controller does not
require a parameter for the I/O address.
Remove the I/O address parameter.
cannot be found at the I/O address
specified.
Action: The Ethernet controller does not
require a parameter for the I/O address.
Remove the I/O address parameter.
PCNTNW-
NW-167
NW-167
PCI scan specified, device not found.
Explanation: The driver cannot locate
the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller
is enabled. If the problem persists, go to
“Starting the diagnostic programs” on
page 11 to run the diagnostic programs.
the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller
is enabled. If the problem persists, go to
“Starting the diagnostic programs” on
page 11 to run the diagnostic programs.
PCNTNW-
NW-180
NW-180
The DMA parameter is not necessary
for PCI device.
for PCI device.
Explanation: The Ethernet controller
does not require a DMA setting.
Action: None necessary, message is for
information only.
does not require a DMA setting.
Action: None necessary, message is for
information only.
Table 2. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller
messages for the Ethernet controller