SonicWALL NSA 6600 Benutzerhandbuch

58

   |   Safety and Regulatory Information  

Safety and Regulatory Information

Safety Instructions

The following conditions are required for proper installation:
• The Dell SonicWALL appliance is designed to be mounted in a standard 19-inch 

rack mount cabinet. 

• Use the mounting hardware recommended by the rack manufacturer and ensure 

that the rack is adequate for the application.

• Ensure that no water or excessive moisture can enter the unit.
• Allow unrestricted airflow around the unit and through the vents on the side of 

the unit. A minimum of 1 inch (25.44mm) clearance is recommended. 

• Route cables away from power lines, fluorescent lighting fixtures, and sources 

of noise such as radios, transmitters, and broadband amplifiers.

• This product is not intended to be installed and used in a home or public area 

accessible to the general population. When installed in schools, this equipment 
must be installed in a secure location accessible only by trained personnel. 

• Mount in a location away from direct sunlight and sources of heat. A maximum 

ambient temperature of 104º F (40º C) is recommended.

• If installed in a closed or multi-rack assembly, the operating ambient temperature 

of the rack environment may be greater than the room ambient. Therefore, 
consideration should be given to installing the equipment in an environment 
compatible with the maximum recommended ambient temperature.

• Mount the Dell SonicWALL appliances evenly in the rack in order to prevent a 

hazardous condition caused by uneven mechanical loading.

• Four mounting screws, compatible with the rack design, must be used and hand-

tightened to ensure secure installation. Choose a mounting location where all 
four mounting holes line up with those of the mounting bars of the 19-inch rack 
mount cabinet. 

• A suitably rated and approved branch circuit breaker shall be provided as part of 

the building installation. Follow local code when purchasing materials or 
components. 

• Consideration must be given to the connection of the equipment to the supply 

circuit. Appropriate consideration of equipment nameplate ratings must be used 
when addressing this concern. Do not overload the circuit. 

• Reliable grounding of rack-mounted equipment must be maintained. Particular 

attention must be given to power supply connections other than direct 
connections to the branch circuits, such as power strips. 

• The included power cord is  approved for use only in specific countries or 

regions. Before using a power cord, verify that it is rated and approved for use in 
your location. 

• Thumbscrews should be tightened with a tool after both installation and 

subsequent access to the rear of the product. 

• Before replacing the fan unit, carefully read and follow the instructions provided 

with the unit.

The Lithium Battery used in the Dell SonicWALL Internet security appliance may 
not be replaced by the user. The appliance must be returned to a Dell SonicWALL 
authorized service center for replacement with the same or equivalent type 
recommended by the manufacturer. If, for any reason, the battery or 
Dell SonicWALL Internet security appliance must be disposed of, do so following 
the battery manufacturer's instructions.

All Ethernet and RS232 (Console) cables are designed for intra-building 
connection to other equipment. Do not connect these ports directly to 
communication wiring or other wiring that exits the building where the 
Dell SonicWALL is located. 

Regulatory Model/Type

Product Name

1RK27-0A5

NSA 6600