Toshiba IK-WR01A Benutzerhandbuch
11
Installation/Set up
V
iewing
and Operation
Recording
Setting up
Others
Installing the Camera Unit
■ Installation to Wall or Ceiling with Mounting Base (Surface
Mount Installation)
A
B
C
D
Mounting Base
Mounting Base center
Drain groove
Mounting Base center
Drain groove
A
C
B
D
, Wall or Ceiling
, Junction Box
Align to this mark.
In case of using the
variable mounting
holes
variable mounting
holes
Align to this mark.
Rear cable hole
Cable exit
(sideway)
(sideway)
Screws (not supplied)
x4
Fix firmly.
x4
Fix firmly.
Top Cover
Camera Base
Screws
x3
x3
Mount camera base with three supplied
screws A. (Longer screw(M4x16))
Tighten and lock the screws firmly.
screws A. (Longer screw(M4x16))
Tighten and lock the screws firmly.
Cable access hole
ø27 mm (1.06inch)
ø27 mm (1.06inch)
Cable access hole ø27 mm (1.06inch)
With female screw for piping
55 mm
(2.17inch)
(2.17inch)
55 mm (2.17inch)
83.5 mm
(3.29inch)
(3.29inch)
83.5 mm (3.29inch)
85 mm (3.35inch)
85 mm
(3.35inch)
(3.35inch)
46 mm (1.81inch)
46 mm (1.81inch)
7
7
• When installing the camera unit on the
wall, mount it with the drain groove on
the downside. Do not block the drain
groove.
the downside. Do not block the drain
groove.
• When installing the camera unit outdoor,
waterproof the cables. The camera
body is water-resistant but the brackets
are not water-resistant.
body is water-resistant but the brackets
are not water-resistant.
Mount the top cover
(dome cover assembly)
and secure it firmly with
three security screws
using the supplied special
hexangular wrench.
(dome cover assembly)
and secure it firmly with
three security screws
using the supplied special
hexangular wrench.
Unit: mm (inches)