Uniden UDS655 Benutzerhandbuch

8

1.  For each camera, attach the camera  

bracket to the mounting screw. You can 
attach the stand to the top or the 
bottom of the camera as needed.Tighten 
it a few turns, then turn the camera to 
face the direction you want. 

2.  Tighten the camera brace up against the 

camera to secure it into place.

3.  Unlock the mounting post by turning 

the wingnut to the left a few turns.

4.  Set the mounting post to the correct 

angle, then tighten the wingnut until the 
post is locked into place.

5.  Attach the antenna to the rear of the 

camera. 

6.  Connect one end of an AC adapter to the camera’s power pigtail and plug the other end into 

a 120 volt AC (standard indoor) power outlet. (If necessary, connect the extension cord to the 
camera’s pigtail and connect the AC adapter to the extension cord.)
Be sure the power plug and the connector are tightly twisted together to avoid water 
leaking in.

7.  Make sure the Power status light turns on. If it doesn’t, try reconnecting the AC adapter, and 

make sure the power outlet isn’t controlled by a wall switch.

1.  Remove the protective plastic from the monitor screen.
2.  Flip out the stand on the back of the monitor and extend the antenna. 
3.  Connect an AC adapter to the power input on the side of the monitor. 

Loosen the 

wingnut to 

unlock the 

mounting 

post.

Attach the camera 

to the mounting 

screw and turn it 

to the desired 

direction.

Adjust the post to 

the correct angle, 

then tighten the 

wingnut to lock the 

post into place.

Tighten the brace against 

the camera to

secure it

in place.