Petsafe PIG20-11041 Benutzerhandbuch

Seite von 116
www.petsafe.net 9 
Prepare the Receiver Collar
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe
®
 battery 
(RFA-188). This unique battery is designed to make battery 
replacement easier and increase water protection.
To activate the collar, insert the battery module (5A). Using the 
edge of the Test Light Tool as shown, turn the battery clockwise 
until the vertical line on the battery is pointed to the “ON” 
position (5B). If the PetSafe
®
 Receiver Collar is not going to be 
used on the pet immediately, leave it in the “OFF” position.
To remove the battery, turn the battery counter-clockwise using 
the edge of the Test Light Tool as shown (5C, 5D). DO NOT 
attempt to cut into or pry open the battery. Be sure to discard the 
used battery properly.
A replacement PetSafe
®
 battery can be found at many retailers. 
Contact the Customer Care Centre or visit our website at 
www.petsafe.net to locate a retailer near you.
Two Colour LED 
The two colour LED indicator shows good or low battery. Good 
battery equals 1 fl ash every 60 seconds with Green LED. Low 
5A
5B
5D
5C
battery equals 3 fl ashes every 60 seconds with the Red LED. If there are no LED lights it is time to change the battery. 
To Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. With the battery installed, press the Correction Level Button and release when the 
Receiver Indicator Light lights red (5E).
2. The Receiver Indicator Light will emit a number of red fl ashes representing the Static 
Correction Level (5F).
3. Increase the Static Correction Level by pressing and releasing the Correction Level 
Button within 5 seconds of the previous fl ashes.
The Static Correction Levels increase from 1 to 5. Pushing the Correction Level Button while 
the Receiver Collar is on level 5 will cause the Receiver Collar to revert to level 1. Refer to the 
Function and Response Table to choose the Static Correction level that best fi ts your pet.
5E
5F
The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains in 
the Static Correction Zone if the collar is set at level 2 or above. 
The Receiver Indicator Light acts as a low battery indicator, fl ashing every 60 seconds when battery replacement is required. 
Test your Receiver Collar at least once a month to verify that it is functioning properly. Check that it activates at the 
Boundary Wire.
Over Correction Protection
In the unlikely event that your pet “freezes” in the Static Correction Zone, this feature limits the static correction duration
to 30 seconds. The system locks out further static correction until the pet leaves the Static Correction Zone.
Function and Response Table
Note: Begin training with Static Correction Level 2 and only increase if your pet does not respond to the Static Correction.
Indicator Light Response Static Correction Level Receiver Collar Function
Temperament of Pet
1 Red Flash
1
No Static Correction, Tone  Only
2 Red Flashes
2
Low Static Correction
Timid
3 Red Flashes
3
Medium Static Correction
Timid or Average
4 Red Flashes
4
Medium High Static Correction
Average or High Energy
5 Red Flashes
5
High Static Correction
High Energy
Flashes 3 Red Flashes 
every 60 seconds
Low Battery
Step
5