TEAC LP-P1000 Benutzerhandbuch
17
EN
G
LI
SH
Replacing the stylus
o
Record styluses are precision parts, so handle them
carefully to avoid bending or damaging their tips. If
a stylus becomes bent or damaged, it might not be
able to follow the audio groove precisely and could
damage records or cause other malfunction.
carefully to avoid bending or damaging their tips. If
a stylus becomes bent or damaged, it might not be
able to follow the audio groove precisely and could
damage records or cause other malfunction.
o
If a stylus becomes dirty, use a commercially avail-
able stylus cleaner or similar product to clean it.
able stylus cleaner or similar product to clean it.
o
Do not rub the stylus tip forcefully with anything
hard. Do not wipe the stylus with thinner or other
chemicals. Doing so could harm it.
hard. Do not wipe the stylus with thinner or other
chemicals. Doing so could harm it.
Replacing the stylus
Using a record stylus wears it down, which could cause
the sound quality to worsen and possibly damage
records. Replace the stylus with a replacement stylus
specified by TEAC as early as possible. In general, you
should replace a sapphire stylus for LP and EP records
after about 50 hours of use and a diamond stylus for SP
records after about every 100 hours.
the sound quality to worsen and possibly damage
records. Replace the stylus with a replacement stylus
specified by TEAC as early as possible. In general, you
should replace a sapphire stylus for LP and EP records
after about 50 hours of use and a diamond stylus for SP
records after about every 100 hours.
CAUTION
o
Since loud noises could suddenly occur, put the unit
into standby before changing the stylus.
into standby before changing the stylus.
o
Be careful not to hurt your hand or the equipment.
o
Be careful not to allow small children to accidentally
swallow styluses.
swallow styluses.
Removing the stylus (red part)
1
Press the STANDBY/ON button to put
the unit into standby.
the unit into standby.
2
Hold the cartridge with one hand, and
use a small screwdriver or other tool to
push the level difference at the front
of the stylus down in the “A” direction.
Then, pull it forward and off.
use a small screwdriver or other tool to
push the level difference at the front
of the stylus down in the “A” direction.
Then, pull it forward and off.
Screwdriver
Attaching a new stylus
1
Insert it in the “B” direction so that the
end of the stylus fits into the cartridge.
end of the stylus fits into the cartridge.
2
Push in the “C” direction until it snaps
into place.
into place.
Replacement styluses (sold separately)
STL-103: Sapphire stylus for LP and EP records
(3 per set)
SPL-102: Diamond stylus for SP records
(2 per set)
For replacement styluses, contact your dealer or
TEAC customer support (see the back cover).
TEAC customer support (see the back cover).