Garmin GTN6XX Benutzerhandbuch

Seite von 160
190-01007-A1
System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Rev. 7
Page 5-15
5.3.1.7 Datalink Related Alerts
Table 5-9.  Datalink Alert Troubleshooting Guide
Alert Text
Possible Cause
Corrective Action
DATALINK – GDL 69 is 
inoperative or connection to 
GTN is lost.
The GTN cannot communicate 
with the GDL 69.
Check for proper configuration.
Ensure the GDL 69 is powered 
up.
Verify that the GDL 69 
Ethernet ports are enabled. 
HSDB data from the GDL 69 
can be routed to the GTN 
through other Garmin LRUs. 
Ensure that all Garmin LRUs 
are powered up.
DATALINK – GDL 88 is 
inoperative or connection to 
GTN is lost.
The GTN cannot communicate 
with the GDL 88.
Check for proper configuration.
Ensure the GDL 88 is powered 
up.
HSDB data from the GDL 69 
can be routed to the GTN 
through other Garmin LRUs. 
Ensure that all Garmin LRUs 
are powered up.
DATALINK - GDL 88 ADS-B 
failure. Unable to transmit 
ADS-B messages.
GDL 88 is not able to transmit 
an ADS-B message due to a 
failure with the GDL 88 system 
or antenna(s).
Check the GDL 88 Fault page 
in configuration mode on the 
GTN.
Refer to the GDL 88 STC 
Installation Manual.
DATALINK – GDL 88 ADS-B 
fault.
The GDL 88 has detected a 
fault with one of the GDL 88 
UAT/1090 antennas.
Refer to the GDL 88 STC 
Installation Manual.
DATALINK – ADS-B fault: UAT 
receiver.
The GDL 88 has detected a 
UAT receiver fault.
Refer to the GDL 88 STC 
Installation Manual.
DATALINK – ADS-B fault: 
1090 receiver.
The GDL 88 has detected a 
1090 receiver fault.
Refer to the GDL 88 STC 
Installation Manual.
DATALINK - GDL 88 ADS-B is 
not transmitting position. 
Check GPS devices.
The GDL 88 has detected a 
position input fault.
Refer to the GDL 88 STC 
Installation Manual.
DATALINK - GDL 88 control 
panel input fault. Check 
transponder is in correct mode.
The GDL 88 has lost 
communication with the 
transponder.
Refer to the GDL 88 STC 
Installation Manual.
DATALINK - GDL 88 ADS-B 
fault. Pressure altitude input is 
invalid.
The GDL 88 has lost 
communication with the 
pressure altitude source.
Refer to the GDL 88 STC 
Installation Manual.
DATALINK - GDL 88 ADS-B 
traffic has failed.
GDL 88 may have lost GPS 
position.
The GDL 88 has detected an 
internal failure.
Check the GDL 88 Fault page 
in configuration mode on the 
GTN.
Refer to the GDL 88 STC 
Installation Manual.