Sanus Systems LA112 Benutzerhandbuch

6901-100189 <01>

CSAV, Inc. and its affiliated corporations and subsidiaries (collectively, “CSAV”), intend to make this manual accurate and complete. However, CSAV makes no claim that the information 
contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information 
contained in this document is subject to change without notice or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the information 
contained herein. CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. 

Controlling X-arm™ with Home Automation (RJ11/RS232 port) 

X-arm

™

 X700CS and X700CB (not available on the X700RS and X700RB) can be controlled through 

Home Automation remote controls and control panels such as those made by Crestron, AMX, Control4 

and life|ware.  To do this, do the following:

1. Using a philips screw driver, remove both screws from the cover plate located at the bottom, right-hand side of 
the control box.

2. Remove the cover plate to expose the RS232 port.

3. Download the RS232 program from the Home Automation vendor’s web site.

4. Plug the home automation control into the RS232 port on X-arm™ running the cord out the back hole in the 
back plate of X-arm™.  

5. Replace the cover plate and secure it in place with the screws. 

6. Follow the vendor’s instructions.

RJ11/RS 232 

Port

Cover Plate