JVC DT-3D24G1 Benutzerhandbuch
15
SPLIT
L image is displayed on the left of the SPLIT line, and R image on
the right. You can check the difference between the images from
the two cameras.
the right. You can check the difference between the images from
the two cameras.
LR SEQ.
Images for the left and right eyes are displayed alternately at
0.5-second interval.
0.5-second interval.
●
A marker appears on the upper part of the screen, which
distinguishes between L and R images.
L image: Upper left
R image: Upper right
R image: Upper right
R SHIFT
L and R images are overlapped. You can move the R image
horizontally and check the difference between the images.
horizontally and check the difference between the images.
●
While “R SHIFT” is active, the images are corrected according to
the check using the circular polarizing glasses.
ANAGLYPH
L and R images colored red and blue separately are overlapped.
You can move the R image horizontally and check the difference
between the images.
You can move the R image horizontally and check the difference
between the images.
INDIVIDUAL
Either L image or R image is displayed.
●
Each time you press SELECT button, the picture changes in the
following order.
●
A marker appears on the upper part of the screen, which
distinguishes between L and R images.
L image: Upper left
R image: Upper right
R image: Upper right
LR SWAP
L and R images are exchanged and then displayed. You can
exchange the images without repluging the terminals.
exchange the images without repluging the terminals.
●
The setting is retained even when the menu closes. Note that L
and R images have been exchanged when the setting is set to
“ON.”
“ON.”
L image
R image
SDI IN
SDI IN
1/L 2/R
SDI IN
SDI IN
1/L
2/R
LR SWAP “OFF”
LR SWAP “ON”
L and R images not correspondent
L and R images correspondent
H line
L
R
L
R
0.5 sec.
0.5 sec.
0.5 sec.
0.5 sec.
L image
R image
L image
R image
H line
SPLIT line
L
POSITION knob/PUSH SEL. button
You can move the displayed SPLIT line/H line/R image (only in “R SHIFT” or “ANAGLYPH”) by turning
the POSITION knob.
the POSITION knob.
To move right/up: Turn the POSITION knob clockwise.
To move left/down: Turn the POSITION knob counterclockwise.
To select a line to move: Press the PUSH SEL. button.
●
Pressing and holding the PUSH SEL. button for 3 seconds or longer resets the lines and R image to the default positions.
●
The intensities of the SPLIT and H lines can be changed in “L. INTENSITY” under the MAIN MENU “3D SETTING.” (→page 19)
DT3D24G1_EN.indb 15
DT3D24G1_EN.indb 15
11.1.25 0:53:50 PM
11.1.25 0:53:50 PM