Desa 11174-01 Benutzerhandbuch

107705

www.desatech.com

ENGLISH

OPERATING CHAIN SAW

WARNING: Read and understand this

owner’s manual before operating this saw.

Make certain you read and understand all

Important Safety Information, pages 3

through 5. Improper use of this chain saw

can cause severe injury or death from

ﬁre, electrical shock, or body contact with

moving chain, or falling wood.

Continued

Approx.

1/8"

TIGHTEN

TIGHT

SAW CHAIN TENSION

ADJUSTMENT

Continued

Turn chain tensioning knob clockwise
to tension saw chain...

Pull chain to check tension. Guide
links should not come out of guide
bar groove...

Make sure chain moves freely around
guide bar then tighten both nuts.

FILLING OIL TANK

1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil.

Note: For

temperatures below 30°F, use SAE #10 oil. For

temperatures above 75°F, use SAE #40 oil.

3. Replace oil cap at once. Tighten oil cap ﬁrmly for

good seal. This will avoid oil seepage from tank.

4. Wipe off excess oil.
Note: It is normal for oil to seep when saw is not in use.

Empty oil tank after each use to prevent seepage.

OILING CHAIN
Manual Oil System

Always check oil level before using saw. Do not

attempt to operate the oil system while saw is in

operation. To oil chain, press squeeze bulb. Oil will

feed onto the guide bar and chain. Press squeeze bulb

at least once before each cut. Check oil level often by

looking at oil sight window (see Figure 7).

Automatic Oil System

Chain saw Model 107625-01, -02, 111174-01 is

equipped with an automatic oiling system. It will

provide adequate lubrication to the guide bar and saw

chain. Check oil level every 15 minutes of cutting time.

Oil level can be seen in oil sight window (see Figure

8, page 10).

Guide Bar

Models 107625-01,

107625-02, and

111174-01

Figure 7 - Oil Squeeze Bulb and Oil Sight Window

Location for Model 107624-01, -02

Oil Sight Window

Oil Squeeze Bulb