Zenoah BK4310FL Benutzerhandbuch
12
■ BLADE
• Never attach nor remove a cutting blade while the
engine is running.
• Use ZENOAH genuine cutting blade for exchange.
• Wear sturdy gloves for attaching/removing a
• Wear sturdy gloves for attaching/removing a
metallic cutting blade to avoid injury.
1. Loosen the nut, remove holder A and holder B from
the gear case. (SE10)
(Note that this is a left-turning screw.)
(1) Bar
(2) Holder B
(3) Holder A
(2) Holder B
(3) Holder A
2. Attach the cover (SE11,(11)) and fix it with screw.
3. Insert blade between cutter holder A and cutter holder
3. Insert blade between cutter holder A and cutter holder
B. (SE11)
4. Attach cover and spring washer. (SE11)
5. Screw the bolt to fix them into place. (SE11)
5. Screw the bolt to fix them into place. (SE11)
Tightening torque:
14.7~19.6 N-m/150~200kgf-m
■ LINE HEAD (SE11)
1. Detach bolt (1), spring washer (2), washer(3), bolt
1. Detach bolt (1), spring washer (2), washer(3), bolt
cover (4) and cover (11).
2. Put holder B (5) to holder A (9).
Screw arbor bolt (12) in holder B (5).
3. Then attach the cutting head to the gear shaft over
the holders. Hard-tighten it securely.
(1) Bolt
(2) Spring Washer
(3) Washer
(4) Bolt cover
(5) Holder B
(6) Blade
(7) Gear shaft
(8) Bar
(9) Holder A
(10) Gear case
(11) Cover preventing grass from getting caught up
(12) Arbor bolt
(2) Spring Washer
(3) Washer
(4) Bolt cover
(5) Holder B
(6) Blade
(7) Gear shaft
(8) Bar
(9) Holder A
(10) Gear case
(11) Cover preventing grass from getting caught up
(12) Arbor bolt
WARNING
SE10
SE11
4. SET UP